How to write a scientific reportWhat goes in each section, with a short example
A practical report follows the same structure from Year 7 to the HSC. Once you know what each section is for, writing one becomes much quicker, and the marks are easier to find. Schools vary a little, so always check the task notification as well.
- Years 7 to 12
- Science, Physics, Chemistry, Biology
- Updated November 2026
The sections, in order
| Section | What goes in it |
|---|---|
| Title | What was investigated, in a few words. |
| Aim | One sentence: what the experiment set out to do, naming the variables. |
| Hypothesis | Your testable prediction, with a reason. |
| Materials | A list of everything used, with sizes and amounts, such as “250 mL beaker” or “50 mL of 1.0 mol/L hydrochloric acid”. |
| Risk assessment | The hazards, the risk each one poses, and how you reduced it. |
| Method | Numbered steps, detailed enough for someone else to repeat the experiment exactly. |
| Results | Tables and graphs of your data, with units. No explanations here. |
| Discussion | What the results show, the science that explains them, how good the data is, and how to improve the experiment. |
| Conclusion | A short answer to the aim, and whether the hypothesis was supported. |
| References | Any sources you used, if the task asks for them. |
Writing a method someone could follow
The test of a good method: could another student repeat your experiment exactly, without asking you anything? Give amounts, sizes, times and how each measurement was taken.
Weak
Add acid to the marble chips and time it.
Strong
1. Measure 50 mL of 1.0 mol/L hydrochloric acid with a measuring cylinder and pour it into a conical flask. 2. Add 2.0 g of marble chips and start the stopwatch. 3. Record the volume of gas collected in the gas syringe every 30 seconds for 5 minutes.
Gives the amounts, the equipment and exactly what is measured and when.
Risk assessments
A risk assessment links each hazard to what could happen and what you did about it. Be specific to your experiment, not generic.
| Hazard | Risk | Precaution |
|---|---|---|
| 1.0 mol/L hydrochloric acid | Irritation if it splashes onto skin or into eyes | Wear safety glasses; wipe up spills; rinse skin with water |
| Glassware | Cuts from broken glass | Check for cracks; tell the teacher about breakages; don’t pick up broken glass by hand |
| Hot plate | Burns | Don’t touch the plate; let equipment cool before moving it |
The discussion: where most marks are
The discussion is usually the longest section and carries the most marks. A strong discussion covers:
What a good discussion includes
- The trend in the results, with numbers from your data.
- The scientific explanation for that trend.
- Whether the results support the hypothesis.
- Validity, reliability and accuracy, with specific reasons.
- The main sources of error, their type, and which way they pushed the results.
- Specific improvements, each matched to a problem you identified.
A short example report
Here is a short report on a simple Year 7 to 10 practical, so you can see how the sections fit together. The data is example data.
Bounce height of a tennis ball
Aim: To investigate how the drop height of a tennis ball affects its bounce height.
Hypothesis: If the drop height increases, then the bounce height will increase, because the ball has more gravitational potential energy to convert into kinetic energy.
Method (summary): A metre ruler was taped vertically to a wall. The ball was dropped from rest from six heights, measured to the bottom of the ball, onto the same hard floor. Each bounce was filmed on a phone and the highest point of the bottom of the ball was read from the video. Three trials were done at each height.
| Drop height (cm) | Trial 1 (cm) | Trial 2 (cm) | Trial 3 (cm) | Mean bounce height (cm) |
|---|---|---|---|---|
| 20 | 11 | 10 | 11 | 10.7 |
| 40 | 21 | 22 | 21 | 21.3 |
| 60 | 32 | 31 | 33 | 32.0 |
| 80 | 42 | 44 | 43 | 43.0 |
| 100 | 53 | 52 | 54 | 53.0 |
| 120 | 63 | 61 | 64 | 62.7 |
Discussion: The bounce height increased steadily with drop height, and a graph of the means is a straight line with a gradient of about 0.52. The ball returned to roughly half its drop height each time, because some kinetic energy was converted into heat and sound when it squashed against the floor. The results support the hypothesis. The method was valid because only the drop height changed: the same ball and floor were used, and every height was measured to the bottom of the ball. Results were reliable, with the three trials within 3 cm of each other at every height. Reading the top of the bounce from the video still involved some judgement, a random error; using a phone’s slow-motion setting would make the highest point easier to see.
Conclusion: As drop height increased from 20 cm to 120 cm, bounce height increased in proportion, to about 52% of the drop height. The hypothesis was supported.
Writing the conclusion
Keep it short. Answer the aim directly, give the key result, and say whether the hypothesis was supported. Don’t introduce anything new.
Weak
The experiment was a success and we learnt a lot about bouncing balls.
Strong
As drop height increased, bounce height increased in proportion, to about 52% of the drop height. The hypothesis was supported.
Answers the aim with the actual result.
Common mistakes
Explaining results in the Results section.
Instead: Results is for tables and graphs. Explanations go in the discussion.
A method with no amounts or sizes.
Instead: Give volumes, masses, concentrations and times so it can be repeated.
A conclusion that doesn’t answer the aim.
Instead: Restate the aim as an answer, using your result.
Writing “human error” as the only source of error.
Instead: Name the actual error and say whether it is random or systematic.
Improvements that don’t match a problem.
Instead: For each problem you identify, give one specific fix.
Copying a generic risk assessment.
Instead: List the hazards of your experiment and what you actually did about them.
Exam-style questions
A student’s method says: “Add acid to the chips and time it.” Identify three pieces of information missing from this step. 3 marks
Show a model answer
Any three of: the volume of acid, the concentration of acid, the mass or size of the marble chips, what is being timed or measured (for example gas volume every 30 s), and how long the measurements continue.
Distinguish between the discussion and the conclusion of a scientific report. 2 marks
Show a model answer
The discussion analyses the results: it explains the trend using science, assesses validity, reliability and accuracy, identifies errors and suggests improvements. The conclusion is a short statement that answers the aim and says whether the hypothesis was supported.
Write a conclusion for an experiment where the time for a sugar cube to dissolve fell from 210 s at 20 °C to 60 s at 80 °C. 2 marks
Show a model answer
As the water temperature increased from 20 °C to 80 °C, the time for the sugar cube to dissolve decreased from 210 s to 60 s. Sugar dissolves faster in hotter water. (If there was a hypothesis, add whether it was supported.)
Questions students and parents ask
Should a scientific report be written in first person?
Many schools ask for third person and past tense in the method and discussion, such as “The ball was dropped from 20 cm”. Some accept first person. Check your task notification or ask your teacher.
What is the difference between the discussion and the conclusion?
The discussion analyses and explains the results, including errors and improvements. The conclusion is one to three sentences answering the aim.
Does every report need a hypothesis?
Most investigations testing a relationship should have one. A practical that only measures a value, such as the density of a metal, may only need an aim.
How long should a discussion be?
Long enough to cover the trend, the science behind it, the quality of the data and improvements. For a school practical that is often three to six paragraphs. Check any word limit in the task notification.
Keep going
Practise with our free notes and quizzes: Year 7 Science notes Year 11 Chemistry notes
Coaching Centre